论坛回复已创建
-
帖子
-
可能没读懂我的意思，我不是说修改传输过来数据的名字，而是这个服务器连接蓝牙后显示的名字，我知道服务器是根据UUID现实名称，我自己加服务器显示的是UnKnown Service，我现在想知道我怎么添加代码让我的这个自定义服务器有自己的名字如：Spectral measurement
在\rv32m1_sdk_riscv\boards\rv32m1_vega\wireless_examples\bluetooth\heart_rate_sensor例程中做的修改，例程中的如心跳服务器，电池服务器等都有名称，如Heart Rate,Battery Service,自己加的就是UnKnown Service
void BOARD_InitPins(void) {
CLOCK_EnableClock(kCLOCK_PortA);
CLOCK_EnableClock(kCLOCK_PortC); /* Clock Gate Control: 0x01u */
CLOCK_EnableClock(kCLOCK_PortE); /* Clock Gate Control: 0x01u */const port_pin_config_t porte12_pinL12_config = {
kPORT_PullDisable, /* Internal pull-up/down resistor is disabled */
kPORT_FastSlewRate, /* Fast slew rate is configured */
kPORT_PassiveFilterDisable, /* Passive filter is disabled */
kPORT_OpenDrainDisable, /* Open drain is disabled */
kPORT_LowDriveStrength, /* Low drive strength is configured */
kPORT_MuxAsGpio, /* Pin is configured as PTE12 */
kPORT_UnlockRegister /* Pin Control Register fields [15:0] are not locked */};
PORT_SetPinConfig(PORTE, PIN12_IDX, &porte12_pinL12_config); /* PORTE12 (pin L12) is configured as PTE12 */
PORT_SetPinMux(PORTA, PIN24_IDX, kPORT_MuxAsGpio); /* PORTA24 (pin D6) is configured as PTA24 */
PORT_SetPinMux(PORTC, PIN7_IDX, kPORT_MuxAlt3); /* PORTC7 (pin N2) is configured as LPUART0_RX */
PORT_SetPinMux(PORTC, PIN8_IDX, kPORT_MuxAlt3); /* PORTC8 (pin P3) is configured as LPUART0_TX */
}#define BOARD_SW5_GPIO GPIOE
#define BOARD_SW5_PORT PORTE
#define BOARD_SW5_GPIO_PIN 12U
#define BOARD_SW5_IRQ PORTE_IRQn
#define BOARD_SW5_IRQ_HANDLER PORTE_IRQHandler
#define BOARD_SW5_NAME “SW5”/* Board led color mapping */
#define BOARD_LED_RED_GPIO GPIOA
#define BOARD_LED_RED_GPIO_PIN 24U/*! @brief The TPM channel used for board */
#define BOARD_TPM_CHANNEL 0U
